New hawk carb mod questions

[Riggs]

I have completed sprocket mod 17/45 & have done air box mod. Also mod on stock carb with motocheese's instructions with 115 jet & needle shim 2 washers. Bike runs good so far. 300 miles

Purchased VM26 Mikuni Carb & awaiting ebay exaust.

Need advice on new Mikuni carb jetting & tuning with all mods at sea level.

Thanks............... :thanks:

[Megadan]

I have completed sprocket mod 17/45 & have done air box mod. Also mod on stock carb with motocheese's instructions with 115 jet & needle shim 2 washers. Bike runs good so far. 300 miles

Purchased VM26 Mikuni Carb & awaiting ebay exaust.

Need advice on new Mikuni carb jetting & tuning with all mods at sea level.

Thanks............... :thanks:

At sea level in the cooler months. Start with a 30 pilot and a 120 main with the needle in the center slot. Likely going to be a little bit rich, but there are a few guys that run close to the same at sea level with exhaust and intake. From there you just gotta dial it in. I would have a 27.5 pilot, and a couple of sizes up and down for the main jet as well to help dial it in.