Bashan Storm Mods, YouTube link!

[Cravin01]

Here we go!

Another link to a link.

http://chinariders.net/showthread.php?t=21028

[Cravin01]

Another video link for you guys, Digital clust will soon follow.

http://chinariders.net/showthread.php?p=285344#post285344

[tomrom]

Hi, How did you get the Storm 250 sticker off? Mine seems to be clear coated over.

[Cravin01]

Your right it is clear coated, I used a heat gun to get it a little hot and it peals right off.

be aware that the plastics are painted and are white underneath so don't get it too hot, I scratched a small piece of paint off trying to get the sticker to pealing on the edge. I touched up the paint with a permanent marker to hide it.

[Ariel Red Hunter]

Another video link for you guys, Digital clust will soon follow.

http://chinariders.net/showthread.php?p=285344#post285344On drilling stainless steel; I was hired once to repair a stainless steel/fiberglass rudder on boat that had just sailed across from Norway. (Yes, sailed. You know, sails, those big cloth sheets they hang off of a pole?) I seeked advice before I agreed to do the job. "A lot of patience, slow speed, short bites, and Evaporated Milk." "Evaporated Milk?" "Yes, I don't know why it works, just that it does." Do not think it went easily. It took me 4 hours to drill 6 holes through the 1 1/4 inch rudder shaft. And a quarter can of Evaporated Milk....ARH....:wtf:

[Sochin]

ARH, yeah them crazy Norskies when THEY get stranded.....they do it really well too. How do I know? I'm born there :D

[Ariel Red Hunter]

ARH, yeah them crazy Norskies when THEY get stranded.....they do it really well too. How do I know? I'm born there :DHe didn't get stranded, the original design was flawed and he was the designer :hehe:, so I worked on it in the boatyard where it had spent the winter. Either the milk casian or butterfat in the milk is why it worked....ARH :p P.S. It was a patch job, it didn't really fix the problem, but he just "Wanted to get by for the season."

[Cravin01]

Update for those using this video for a aftermarket exhaust upgrade:

I found that the header pipe was leaking exhaust due to the flange pulling the pipe toward the side where I decided to just leave the bolt hole, I ended up notching the other side to allow it to pull down evenly without the binding and it seated up nice and even quieting down the bike a bit more.

Also the plastic fender melted in the video as you had seen, I was able to use the bolt and spacer supplied with the exhaust and added four more washers to get the clearance need and will be patching the melted area with a small piece of plate metal to support and protect the fender from this point forward.

I'll be sure to show a quick update and what was done in the next video.

Thanks for watching!

[Cravin01]

Put the update on the exhaust in the vlog and went through rejetting the carb.

http://chinariders.net/showthread.php?p=285569#post285569

[Cravin01]

New Carb finally came in and now its time to get running again, New vid on page 2 of link!

http://chinariders.net/showthread.php?p=287517#post287517

[Cravin01]

The speedometer mod is complete! Vid is a little long but I didn't want to do 2 vidz on the same mod.

http://chinariders.net/showthread.php?t=21028&page=2