selling 2017 Venom x20 "vader2" $1250 'red'

[imapdog]

13879

13880

13881

13882

13883new, assembled, modded, and tuned.
it has less than 20 miles for tuning purposes.
clean/clear tennessee title in my name and on hand.
pickup is in spring hill tennessee 37174.
no trades.
price is very firm.

Modifications done:
Brisk Racing spark plug
oil change
jtr 17tooth-428 front sprocket
jtr 34tooth-428 rear sprocket
jt chain-428
Mikuni vm22 carburetor kit
emissions delete
chrome piranha shorty exhaust(sounds good not too loud)
fender delete kit
photos are actual item
.................
blue will be avail in a week or two.

[Chinabike]

Thats a good deal. :tup:

[JerryHawk250]

Nice :tup: And ready to roll. It doesn't get any better than that. All the hard work has been done.

[kirbo7106]

710 miles from Holiday, Florida to Nashville, Tn! Now that’s a ride!

[natti]

Dang! This is looking nice!
I’m over in Georgia, I’d consider meeting half way, you still modding these bikes? /still available?

[imapdog]

Dang! This is looking nice!
I’m over in Georgia, I’d consider meeting half way, you still modding these bikes? /still available?

sorry, sold out. didnt make $.....went through 6 of them. cool bikes but most thought buying a new stock one was better deal without knowing stock is sub par....wish i could see them peeps now....plus what does little ole me know about motorcycles right? i been flipping for 25 years but no credentials... i needed $1700 a piece to make worthwhile, $1250 was close to cost if not below, and took a while to unload the last two at $1250. of all the chondas and atv's i have flipped, i just ordered another magician 250 green. that was the one i want back....

[cbrfxr67]

glws that's a great $!

[Dexxx702]

Did that exhaust hook up whit no modification?

[Chinabike]

Did that exhaust hook up whit no modification?

Ya. You just have to find a place to mount bracket to hold it up.
Others have use the bolt holes under engine.

[imapdog]

Ya. You just have to find a place to mount bracket to hold it up.
Others have use the bolt holes under engine.

i used one hole under engine. my piranha exhaust has one mounting bracket and one oblong hole on that bracket. i did cut off one end of that oblong hole. the exhaust comes with hardware kit in which i didnt use any of it.
i used 1" chrome spacer rubber and metal washers measured depth of engine hole(dont bottom out bolt) and thread count size. the bracket on the muffler only will connect on opened end using washer. i use 2x 32mm copper crush washers on the engine port.