Vader Exhaust

[Charcoalcash]

Got this exhaust as a bundle deal with my Vader gen 2. Only paid $100 since I bought it with the bike. Original price is $299

Ill post pictures later this week.

[RedCrowRides]

That's a sweet pipe there man, i like that carbon fiber look canister on it, I'll add it to the sites list of parts confirmed to fit Vaders and the source !

[Charcoalcash]

it will look nice on my black bike!

[ripprt1]

Have you fitted to your Vader yet?? That's the same pipe I bought for My hellcat and know way did it fit the head pipe is bent way wrong had to heat the crap out of it to bend it into position just saying

[imapdog]

]interesting. i would love to know if this fits. i doubt it will fit without bending that first turn off the engine exhaust flange...the thickness/length of the exhaust pipe flange looks long enough, but the angle appears off at the first bend in the pipe....

here is paste of my older thread.
"been there done that"
i purchased low mount exhaust for grom:
https://www.ebay.com/itm/SC-Low-Moun...72.m2749.l2649
*
it did not fit in two ways:
1) the Spigot-collar is too short
2) it seems as if it angles off a honda grom engine directly down.
my 125cc lifan on the venom x20 has a slight angle toward the
rear. other words....a 90 degree bend off engine is grom, and
the x20 needs maybe 100 degree bend. not sure if its a difference
of engine being mounted differently or the exhaust hole on engine
is in fact at a different angle from grom to x20.
*
i have read where a pipe adapter fixes a common problem with klx to
honda with:
http://shop.pitsterpro.com/nccpipeadapter.aspx
or maybe stacking some 2-3 Crushable exhaust gaskets:
http://tboltusa.com/store/tech.php?p...+Pipe+Adapters

all said if i can change the depth of my collar and change the angle,
my purchased exhaust would fit.
16520

16521

16522

[ripprt1]

Well here is my experience you have to heat the pipe need a oxy act torch to get it hot enough to bend it be careful it's ss and it can split you'll need a big pipe shoved into the exhaust to bend little steps at a time. And yes 2 copper crush washers will work. The mount for muffler ends up where the rear foot peg is you'll have to remove it and drill a hole for a nut and bolt for the muffler mount good luck