Jet kit help

[Air_male]

Looking for a quality jet kit for this carb. I've used search and get mixed info. I would also like info on removing the egr valve and sourcing a block off plate. I live at sea level so what size jet works, going to open up the airbox too.

[NzBrakelathes]

You will need to pull it down and see what is in it.

Here is my link no doubt it will have an option for you.

https://www.ebay.com/itm/303077495104

[Air_male]

105 main
34 pilot
no adjustment on needle

I had to dremel slots in the tamper proof screws but they came right out and replaced them with new m4 allen head bolts.
Installed 2 3mm washers under c-clip to raise the needle up a bit.
I also took the fuel mix screw out a 1/2 turn.
Plan to order the jet kit from NZ off ebay because it looks like many tuning options.
The question I have is about the 34 pilot, it seems this carb has been seen with a 40 stock from china.
NZ.... can I get a 38 and a 40 pilot as add ons?

[Air_male]

Jets

[NzBrakelathes]

105 main
34 pilot
no adjustment on needle

I had to dremel slots in the tamper proof screws but they came right out and replaced them with new m4 allen head bolts.
Installed 2 3mm washers under c-clip to raise the needle up a bit.
I also took the fuel mix screw out a 1/2 turn.
Plan to order the jet kit from NZ off ebay because it looks like many tuning options.
The question I have is about the 34 pilot, it seems this carb has been seen with a 40 stock from china.
NZ.... can I get a 38 and a 40 pilot as add ons?

As you can see the kit has a 40 in it etc
38 I don’t have but would need to order in extra but going by other info it seems 40 is a good starting point however this hasn’t yet been tested with this jet type (Hawk/Shen Wey is a 40 and the style "A" common Keihin guys run 40-45 on 200-230cc bikes)
It would seem my set is fine for your carb type unless it needs a smaller pilot size then others.

Oh I also HAVE the EGR/Air injection block off plate that you can bolt to the side of the head!