2018 Hellcat throttle

[fastrider450r]

Just received my hellcat last week, neat little bike for the money.
Did a few mods already, exhaust, airbox delete with uni filter, ngk plug, and motor mount and axle/swingarm bolts.

Have handlebars, pz27 carb to change when I get a spare few minutes.

I tried searching, but to no avail, has anyone installed a 1/4 turn twist throttle with the pz27 carb? The 1/2 turn is getting old.

Thanks!

[scoot newb]

People out there with clones have been using this one without any issues except, you may need wider bars to keep the throttle tube from hanging over the edge.

https://www.ebay.com/itm/142005513819


I use a 1/2 turn with multiple mount points.

https://www.amazon.com/Yibid-Motorcycle-Handlebar-Accelerator-Motocross/dp/B078ZV15JL/

[fastrider450r]

Hey thanks! Ordered the 1/4 turn, and I do have wider bars to go on shortly.

[scoot newb]

Nice!

[scoot newb]

Was your cable long enough with the 1/4 twist? You may also need this. https://wholesale-cycle.com/throttle-cable-for-cnc-piranha/

[kirbo7106]

Hey Scoot Newb - how’s your throttle throttle assembly holding up?

[scoot newb]

Fine. I took it off and put lock tight on the threads where the throttle tube screwed into the assembly.