Tbr7 build

[Rich1374670x]

Just assembled a tbr7 and was wondering where these go. Does the nut replace the flatter nut on the front axle? Two little rubber grommets?

[Rich1374670x]

Pics didn't load

[JerryHawk250]

Welcome aboard! Try this.

How to Upload Pics Directly to the Forum
1. You must click on the "Post Reply" button, rather than typing in the "Quick Reply" box.
2. Click on the paper clip symbol.
3. Click "Browse" to find the picture on your hard drive.
4. Click "Upload".
5. Click "Close this window".
6. Click on the paper clip again, and you'll see your picture filename under the "Manage Attachments" header. Click on the filename.

[Rich1374670x]

Think I got it

[kingofqueenz]

Rich...

You are not alone and I have the same bike.

The rubber grommets are a mystery so I saved them.

Yes that nut was for shipping for the front axle to attach to the steel cage.

You replace with the obvious nut in the pack and i actually use that as a secondary we'll call it "lock nut" after the replacement nut is cinched down.

If you do as I do ...don't gorilla tighten that secondary nut on top of the first ( hope this makes sense ).

I literally just returned from riding my TBR ..enjoy the heck out of it and ride safe.

I have a youtube channel with a few vids up.. check it out

https://www.youtube.com/watch?v=cbEAYYPONsU&t=107s

Be safe!

[NzBrakelathes]

rubber grommet sits in bottom of triple tree area and the headlight pins go in there