2013 JL250p-2

[thatkid]

Hoping I can find some info out on this bike. I haven't been able to find a whole lot. All I really know is the motor is a single cylinder clone of a Honda. I need a new chain, which I think is a 428 but I'm not positive. I'm hoping I can spruce her up a bit. Every plastic is cracked or broken and the wiring job was the stuff of legends.

Motor has good compression, carb is cleaned and ready to go back on and I have spark. I just need some time so I can make a small gas gravity feed and see if she runs. Wondering about a new/used tank. The current one has no mounts and it looks like it was on fire at one point. The entire underside looks to be coated in silicone or similar.

Anyone out there have an info on other models that were similar? I've seen the Roketa 113 pop up but that was a twin cylinder.

[franque]

For the gas tank, good luck, parts like that tend to be hard to get. For the chain, watch this video: https://www.google.com/url?sa=t&source=web&rct=j&url=https://m.youtube.com/watch%3Fv%3DHhgzJwTPLC4&ved=2ahUKEwj3jI3kurjrAhUpzYUKHa_iCWwQFjABegQIDBAK&usg=AOvVaw3fmUWi8Uyy1cAgkdGsPkFV

[Falkon45]

https://extreme-bigboystoys.com/listings/mc-jinlun-jl250p-motorcycle/

Try seeing if these guys can get parts. Other than that, you may have to clean, blast, and check the tank for reuse. You could always make it a street fighter. lol.

[thatkid]

https://extreme-bigboystoys.com/listings/mc-jinlun-jl250p-motorcycle/

Try seeing if these guys can get parts. Other than that, you may have to clean, blast, and check the tank for reuse. You could always make it a street fighter. lol.

Normally I prefer a fighter but this has all the plastics. I’ve welded most of them back together and will probably vinyl wrap them down the line. I just don’t want the tank to leak all over and risk catching fire.

[thatkid]

So I guess it's not a honda clone? Oh the places I'll go. It has a lifan 200cc motor in it based on pictures.

I got it started today and it seemed to run alright. I got the scope in the tank and there is definitely a lot of weld going on in there. I can't tell if its from the factory mounting bracket or extra curricular's. It seems to run along the bracket but there are a couple spots that aren't very close to the bracket.

I did verify it's a 428 chain so at least that's sorted. The sprockets seem fine but is there a place to get bigger sprockets for these?

I also wish I could find a part fiche for this bike. The carb bung and tank bung are both vertical, they are different sizes and the tank bung is actually lower than the carb. There's no fuel pump so it seems odd to me. Problem is I can't seem to run a line without it kinking somewhere. Would love to see how it was originally. I just wanted to take it around the block and make sure it shifted ok. That didn't happen. There's always tomorrow.