| alber813 |
02-24-2021 11:43 PM |
200cc Skyteam/DSF 200
Hello, im new around here, i have read lots of posts from here and i decided to come with my first post... i have an UM/DSF 200 or Skyteam ST 200 with lifan 200cc engine (as i learned here hehe), anyways, i bought the motorcycle for a truly good price, had issues with the electrical harness, and the engine had low compression... so, i decided to repair both, made the whole new harness reusing the wires, and its perfect, on the other side the mechanical part... i bought a new cylinder (previous one was broken too!!) and ok it ran fine i have been using it for a while, more than 300miles i guess, the issue is that it always has been consuming a lot of fuel.... so after a while using it and with the first oil change i noticed the oil mixed with fuel!!... idk why, i guess is carburetor related issue? it had a PZ27(27mm carb) which didnt worked (hard to start and no fuel was reaching the engine) i changed it for a PZ30(30mm) as the manual says,so everything was perfect ran 100% for a while, the spark plug (NGK D8EA) had the right color (no fuel deposits, even with the high fuel comsuption)... but suddenly it started to fail very early, even before the first oil change... so idk what it might be, im seeking for some knowledge and help!!
PD: when i did the first dissassembly i noticed that the piston didnt reach the top of the cylinder, the new one dosnt reach as well!! its like 4-6mm away from the top even in its higher point.... this might be the cause of the issue?... i was planning to get it machined properly so it does reach the top but idk... so thats all my issue and my story, im glad to be around here... i will upload some pictures these days... and thanks!!
|
