Resetting the ECU
Have anyone of you had to reset the ECU: this is the method described:
To reset motorcycle ecu, you can follow these steps: Turn off the engine and the ignition switch, and unplug the ecu from your bike. Remove the negative and positive wires from the battery terminal and leave it for 10-15 minutes. Plug the ecu back to your bike, reconnect the battery wires, and turn on the ignition switch. Start the engine and let it idle for a few minutes. I was wondering would this cause any problems on my KPR 200:doh: |
No more than replacing the old ECU unit with a new one!
|
Turns out that all I needed to do was adjust my valve clearances and not bother the ecu or air gulp screw!
|
All times are GMT -4. The time now is 05:20 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.