Question about hand levers
 

Does anyone happen to know which bike(s) the hand levers on the CSC TT250 are patterned after? I’d like to get some adjustable folding levers that fit the stock clutch perch and front master cylinder, but I’m not sure which ones would fit. Thank you in advance.

I can't say which ones they're similar to, but I have these on my TT. I had to grind off the ball-end of the stock levers to fit my hand guards, but eventually wanted these smaller ones for a better fit for my hands. They fit just fine, other than being maybe a half inch away from the master cylinder and left control module instead of snugged right against them like the stock ones.



https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

Likely the same levers the Hawk and other Hawk-like bikes use, but I can't confirm that 100% so some salt grains required.

Honda Grom, Rebel, and most of the other small engine Honda motorcycles.

I use the universal levers on several bikes. These will work on the TT250. https://amzn.to/3IP7l1h

That master cylinder is also a bit of an upgrade. I have that same set and the front brake feel and power improved a good amount.

If you don't already have braided SS brake lines, they are worth it. They really eliminate sponginess altogether.

Thank you for all the replies.