My bars risers
2 Attachment(s)
Couldn't find a thread if there is one on bar risers so figured I'd do this. and share my bar risers. Had two sets made up, one is 3/4" high and one is 1" high. I wanted 1" but at the time I didn't know if there would be enough slack in the wiring harness but there was plenty of slack and so I am use the 1". Stainless steel.
|
A simple and elegant solution, thanks Robin.
|
You are keeping Juan, the machinist, very busy, amigo. :tup:
|
All times are GMT -4. The time now is 12:56 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.