Boom Vader emissions question
I could not get my plastics off because of an awkwardly placed screw underneath the seat that couldn't be removed. I wanted to remove emissions though, so at the information of a youtube video I watched, the fella said to wiggle the charcoal canister and pull it out. Wiggling was an understatement, but I eventually snatched it out. Is there anything that I need to connect/disconnect after doing this? I left everything as-is after pulling the emissions off so I don't know if I need to connect the hoses that came off somewhere. Thanks so much.
Hunt |
Any lines that were previously connected to something, need to be blocked off or plugged.
If you can post up some pictures of what you have now.. I can tell you what to do. I removed the emissions on my vader so I know what goes where and whatnot. You'll have the exhaust recirculation tube that will need to be capped off or a block off plate installed as well. |
A lot of the 'emissions' items fell off while doing my carb upgrade. I plugged the exhaust tubing with some epoxy putty.
https://mymotorcycleblog.com/boom-va...cc-grom-clone/ HTH, |
Get an EGR block off plate and you'll be OK. Plug the air inlet on your stock manifold.
|
All times are GMT -4. The time now is 08:15 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.