Forum: Zongshen RX3
06-04-2017, 02:05 AM
|
Replies: 143
Views: 39,604
Been doing it wrong. Thanks Spud!
So after three tries I couldn't get the valve clearance right.
Thanks to SPUD, it made all sense to me--I was doing it wrong on my first valve clearance check.
It took me 4 tries and two days...
|
Forum: Zongshen RX3
06-04-2017, 12:30 AM
|
Replies: 143
Views: 39,604
Valves no load??
How come the valves are not loaded. They freely go up and down when I line up the TDC using the inspection ports?
Is this how it's supposed to be ? The valves freely go up and down?
|
Forum: Zongshen RX3
06-04-2017, 12:12 AM
|
Replies: 143
Views: 39,604
|
Forum: Zongshen RX3
06-03-2017, 10:35 PM
|
Replies: 143
Views: 39,604
|
Forum: Zongshen RX3
06-03-2017, 10:29 PM
|
Replies: 143
Views: 39,604
Why is it that when I set all four valves to...
Why is it that when I set all four valves to 0.06mm and I crank he engine a couple of times then I go back to TDC. I check my clearance and like clock work, the exhaust valves are so tight that I...
|
Forum: Zongshen RX3
02-05-2016, 08:05 AM
|
Replies: 5,437
Views: 30,149,642
|
Forum: Zongshen RX3
11-17-2015, 03:50 PM
|
Replies: 5,437
Views: 30,149,642
|
Forum: Zongshen RX3
11-15-2015, 09:25 PM
|
Replies: 28
Views: 7,410
Surprise...
Me too. I thought it was going to be remove and replace.
Now I'm going to have to find someone that has a press. If I would have known, I could have asked CSC to install the bearings in it already...
|
Forum: Zongshen RX3
11-15-2015, 09:22 PM
|
Replies: 28
Views: 7,410
|
Forum: Zongshen RX3
11-11-2015, 12:02 AM
|
Replies: 5,437
Views: 30,149,642
|
Forum: Zongshen RX3
11-09-2015, 04:06 PM
|
Replies: 5,437
Views: 30,149,642
|
Forum: Zongshen RX3
11-09-2015, 11:40 AM
|
Replies: 5,437
Views: 30,149,642
I got to the CSC booth on Sunday. CSC Ryan and...
I got to the CSC booth on Sunday. CSC Ryan and Matt sold a few RX3s from the show floor from the previous two days. I was able to talk to Ryan and Matt eventhough they had a stream of folks asking...
|