Go Back   ChinaRiders Forums > Search Forums
Register FAQ Community Calendar Today's Posts Search
Showing results 1 to 21 of 21
Search took 0.00 seconds.
Search: Posts Made By: maqqx
Forum: Dual Sport/Enduro 06-19-2020, 05:30 AM
Replies: 52
Views: 13,433
Posted By maqqx
85 to 90 kph with 15/45 gearing and 18 inch...

85 to 90 kph with 15/45 gearing and 18 inch wheels.
Measured with GPS
125 ccm, 11 HP
Forum: Dual Sport/Enduro 06-12-2020, 03:22 AM
Replies: 12
Views: 1,821
Posted By maqqx
Do you think the root cause of my problems could...

Do you think the root cause of my problems could be deterioration of valve ports?
Forum: Dual Sport/Enduro 06-11-2020, 12:15 PM
Replies: 12
Views: 1,821
Posted By maqqx
Megadan, that's what I was taught too. So I...

Megadan, that's what I was taught too.
So I don't understand how's that possible my bike had bigger valve lash when it was cold. Beacause that's what the mechanic said. The intake was set to 0.08mm...
Forum: Dual Sport/Enduro 06-11-2020, 08:34 AM
Replies: 12
Views: 1,821
Posted By maqqx
I'm not an engineer but if I understand you...

I'm not an engineer but if I understand you correctly it is fine to run a bigger clearence as long as it helps?
Forum: Dual Sport/Enduro 06-11-2020, 07:10 AM
Replies: 12
Views: 1,821
Posted By maqqx
There's a good chance you are right about the...

There's a good chance you are right about the incorrect info. But where to get the correct data from?
My source of information was the official service manual I got with the bike.
I had also...
Forum: Dual Sport/Enduro 06-11-2020, 05:07 AM
Replies: 12
Views: 1,821
Posted By maqqx
I thought this was the case with OHC engines with...

I thought this was the case with OHC engines with a timing chain, but not with the pushrod engines. I'm even pretty sure I've read about it in an old CG125 manual. Well, must've been wrong.
Forum: Dual Sport/Enduro 06-10-2020, 02:38 PM
Replies: 12
Views: 1,821
Posted By maqqx
Pushrod engine valve lash

Until today I was sure the pushrod-type OHV engines tend to increase valve lash when they get hot.

But today it turned out my 156fmi pushrod engine probably does exactly the opposite.
I went to...
Forum: Dual Sport/Enduro 05-30-2020, 10:17 AM
Replies: 14
Views: 2,004
Posted By maqqx
I have a Chikuni VM22 with the pilot jet on the...

I have a Chikuni VM22 with the pilot jet on the fuel side.
Every time I tried to set the idle mixture the engine was warm (I think right in the operating range) but I'm going to give it another try....
Forum: Dual Sport/Enduro 05-29-2020, 01:25 PM
Replies: 14
Views: 2,004
Posted By maqqx
Is that possible my mixture is waaay too rich and...

Is that possible my mixture is waaay too rich and I'm just flooding the engine?
Forum: Dual Sport/Enduro 05-28-2020, 02:14 PM
Replies: 14
Views: 2,004
Posted By maqqx
Zongshen 125 - poor idling and stalling when hot

Three weeks later and I'm still struggling.
I've corrected the fuel level (now it's 3 mm from the carb body) and set the air/fuel mixture again. I've also drained and rinsed the inside of my fuel...
Forum: Dual Sport/Enduro 05-17-2020, 08:09 PM
Replies: 12
Views: 1,329
Posted By maqqx
I'd say it's half by half. That said, I rarely...

I'd say it's half by half. That said, I rarely exceed 70 kph onroad.
Forum: Dual Sport/Enduro 05-17-2020, 03:47 PM
Replies: 12
Views: 1,329
Posted By maqqx
I mostly ride on gravel roads, dirt roads, grassy...

I mostly ride on gravel roads, dirt roads, grassy terrain and pitted back roads. Sometimes mud and sand, too. No steep hills, no woods, no hard off-roading.

I think I'll just go for the TKC. Seems...
Forum: Dual Sport/Enduro 05-17-2020, 06:05 AM
Replies: 12
Views: 1,329
Posted By maqqx
Anyone? My second option is TKC80 Twinduro.

Anyone?
My second option is TKC80 Twinduro.
Forum: Dual Sport/Enduro 05-16-2020, 08:35 AM
Replies: 12
Views: 1,329
Posted By maqqx
50:50 tire choice

I am considering buying two very attractively priced Heidenau tires for my 125cc chinese monster. What would you say about putting a chevron-patterned K60 Scout on the rear and and K41 at the front?...
Forum: Dual Sport/Enduro 05-05-2020, 09:18 AM
Replies: 14
Views: 2,004
Posted By maqqx
Are we online again? ;) There's one thing I've...

Are we online again? ;)
There's one thing I've missed or maybe I should say "failed to measure correctly": the fuel level in my Chikuni is 14 milimeters below the rub of the carb body.
Forum: Dual Sport/Enduro 05-04-2020, 06:52 AM
Replies: 14
Views: 2,004
Posted By maqqx
I did some research and from what I see there are...

I did some research and from what I see there are no resctrictions in these modules. The only difference may be ignition type (AC or DC) and build quality.
Some of them are marketed as...
Forum: Dual Sport/Enduro 05-03-2020, 06:05 PM
Replies: 14
Views: 2,004
Posted By maqqx
Yeah but now to tell those unrestricted units...

Yeah but now to tell those unrestricted units from the rest?
There are several model available, but most of them lacking any description.
Forum: Dual Sport/Enduro 05-03-2020, 12:24 PM
Replies: 14
Views: 2,004
Posted By maqqx
I think so. It has a module called "electronic...

I think so.
It has a module called "electronic ignition module" which is the only piece of eletronics on this bike.
Forum: Dual Sport/Enduro 05-03-2020, 07:55 AM
Replies: 14
Views: 2,004
Posted By maqqx
I'll check the intake for leaks, thank you. As...

I'll check the intake for leaks, thank you.
As for the slide, it's almost new, so I think it's a bit too soon for it to be worn out, but I'll give it a look too.
Forum: Dual Sport/Enduro 05-03-2020, 07:11 AM
Replies: 14
Views: 2,004
Posted By maqqx
125cc Zongshen - poor idling and stalling when hot

Hello everyone!

Last year I've bought a second-hand Chinese 125 motorbike, which is basically a clone of 1970s Honda CG125 (156 FMI pushrod engine). It was running fine, until recently.
Couple...
Forum: New Member Introductions 05-03-2020, 06:46 AM
Replies: 4
Views: 754
Posted By maqqx
Hello from Europe

Hi, I live in Europe and I ride (or at least try to) a Chinese 125cc dual sport bike.
I hope you guys will be able to help me solve some tech issues.
Showing results 1 to 21 of 21

 
Forum Jump

All times are GMT -4. The time now is 07:34 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.