Go Back   ChinaRiders Forums > Search Forums
Register FAQ Community Calendar Today's Posts Search
Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: Thumper
Forum: Registration Issues Today, 10:58 AM
Replies: 0
Views: 30
Posted By Thumper
Thread for Paladin

Successful in Missouri on Halloween (nothing scary). New vehicles have no inspection requirements up to 150k miles in Missouri now. If it did, the Paladin has all necessary lights/horn/etcetera...
Forum: Adventure Bikes Today, 08:45 AM
Replies: 4
Views: 320
Posted By Thumper
You can't take it to just any mechanic. But...

You can't take it to just any mechanic. But CFMoto has brick and mortar stores where a they may have information about it (or maybe even THAT bike to compare it to).

Surf the net. Find owners and...
Forum: Dual Sport/Enduro Yesterday, 09:27 PM
Replies: 6
Views: 514
Posted By Thumper
A petcock for a Hawk is about $25 on ebay. All...

A petcock for a Hawk is about $25 on ebay. All new. Frankly, the rebuild kit will cost less than half of that, depending, but add in the labor and solvents, etc. and the replacement begins to look...
Forum: Dual Sport/Enduro Yesterday, 03:56 PM
Replies: 12
Views: 881
Posted By Thumper
The exhaust tip is removable. It relieves the...

The exhaust tip is removable. It relieves the system and makes the exhaust note more thumpy, less cracky on acceleration. NICE sound

32212

32211


32210
Forum: Dual Sport/Enduro Yesterday, 03:50 PM
Replies: 2
Views: 91
Posted By Thumper
Oh crap! Bad luck. If the shifter shaft is really...

Oh crap! Bad luck. If the shifter shaft is really gone, you will be cracking open the engine to replace it. I don't think you can replace it otherwise. Good luck!
Forum: Dual Sport/Enduro Yesterday, 03:10 PM
Replies: 1
Views: 97
Posted By Thumper
Should be an easily waranteed item. Make a short...

Should be an easily waranteed item. Make a short video and offer a link if they want evidence. PSM always takes care of this kind of thing.

I just took a ride. Lots of fun including some offroad...
Forum: Dual Sport/Enduro Yesterday, 11:00 AM
Replies: 7
Views: 204
Posted By Thumper
That would be really convenient. You could keep a...

That would be really convenient. You could keep a second chain optimize for the alternate sprocket.

I just added my new S8-KE300 (Paladin) to my Geico policy. The annual premium went from $118 to...
Forum: Dual Sport/Enduro Yesterday, 06:33 AM
Replies: 50
Views: 2,014
Posted By Thumper
Zuumav sticker!

I have searched but haven't been able to find stickers with the Zuumav logo. I'd like xarious sizes. Zuumav lets their distributors put their logo on them, but it is a Zuumav! Zongshen and Loncin do...
Forum: Dual Sport/Enduro 10-29-2024, 10:01 PM
Replies: 7
Views: 204
Posted By Thumper
Yup. Those are the wheels. And that's the lowest...

Yup. Those are the wheels. And that's the lowest price I have seen. I think KKE has a set for closer to $400. They claim Honda CR250 fitment (and other Hondas). I am sure it fits Templar.
Forum: Dual Sport/Enduro 10-29-2024, 07:41 PM
Replies: 50
Views: 2,014
Posted By Thumper
That video is typical so far on the Paladin. A...

That video is typical so far on the Paladin. A few revolutions, then it starts. Same experience with my neighbor's KPX. Has to crank a couple of revolutions.

My son's Templar (and my previous...
Forum: Dual Sport/Enduro 10-29-2024, 07:00 PM
Replies: 7
Views: 204
Posted By Thumper
I would ignore this product! How useless to...

I would ignore this product! How useless to advertise a product based on wht it does not fit. Ya think they will sell many, or have many return requests!!! :wtf:

You want the Honda compatible...
Forum: Dual Sport/Enduro 10-29-2024, 06:08 PM
Replies: 50
Views: 2,014
Posted By Thumper
No issue. It idles. It settled into a steady idle...

No issue. It idles. It settled into a steady idle when I got back from the first ride.

Stalling can happen with EFI under no load once in a while, particularly when you drop the throttle...
Forum: Dual Sport/Enduro 10-29-2024, 04:30 PM
Replies: 50
Views: 2,014
Posted By Thumper
Like most assemblers, they use cordless drivers...

Like most assemblers, they use cordless drivers on everything. They do not bother to hand start/thread. So some get cross threaded from the start on perfectly good threads. Shame they can't see this...
Forum: Dual Sport/Enduro 10-29-2024, 02:57 PM
Replies: 50
Views: 2,014
Posted By Thumper
kickstand spring-fixed

I removed the lower kickstand mounting "plate" and put it in a vice so I could drill another hole close to the mounting bolt. Then I used a broad punch and hammer to bend it so the spring is held off...
Forum: Dual Sport/Enduro 10-29-2024, 01:32 PM
Replies: 50
Views: 2,014
Posted By Thumper
Thanks! I got my cowling wings straight and...

Thanks!
I got my cowling wings straight and assembled without my oak block and nylon post...
I should have applied the standard old rule, loosen everything, align things and then begin to tighten...
Forum: Dual Sport/Enduro 10-29-2024, 10:51 AM
Replies: 3
Views: 123
Posted By Thumper
You won't be any more experienced to jet a new...

You won't be any more experienced to jet a new carb. Chances are it won't have the right jets for your bike. Either way, you need to buy jets. Why don't you buy a complete set (like $10-$15) and...
Forum: Dual Sport/Enduro 10-28-2024, 08:25 PM
Replies: 50
Views: 2,014
Posted By Thumper
Short night ride to check the headlight strength....

Short night ride to check the headlight strength. It seems brighter than I expected, but it is aimed low and is cut off by the front fender. I will look for a height adjustment screw tomorrow when I...
Forum: Dual Sport/Enduro 10-28-2024, 08:02 PM
Replies: 12
Views: 881
Posted By Thumper
I installed a Battery Tender lead (fused). I can...

I installed a Battery Tender lead (fused). I can check voltage there. The connector looks identical, though not sure about polarity. I routed it through the gap over the air filter panel.
Forum: Dual Sport/Enduro 10-28-2024, 06:27 PM
Replies: 9
Views: 354
Posted By Thumper
The key phrase in bigdano's post is "You get to...

The key phrase in bigdano's post is
"You get to really know the bike. ALL of it."

No matter what the quality of these bikes, they will need attention. But that is not unique to Chinese dirtbikes....
Forum: Dual Sport/Enduro 10-28-2024, 05:46 PM
Replies: 50
Views: 2,014
Posted By Thumper
Each block on the tach represents 500rpm. Not...

Each block on the tach represents 500rpm. Not exaclty a fine indicator! I am just looking at the tachometer. Should connect a digital rpm tool. Forum member readout mentioned ~the same (2000rpm)....
Forum: Dual Sport/Enduro 10-28-2024, 02:17 PM
Replies: 9
Views: 354
Posted By Thumper
I just made some comments in the minor assembly...

I just made some comments in the minor assembly issues thred.
At your height and weight, the additional power and overall stronger/stiffer build and 14 more hp would be useful to you. And that is...
Forum: Dual Sport/Enduro 10-28-2024, 11:54 AM
Replies: 50
Views: 2,014
Posted By Thumper
First heat cycle and test ride

It started right up. The exhaust is sealed and quiet at the header. That's a relief. 10 minute ride, gentle to modest throttle, kept it under 6000rpm. I never got it over 35mph. Just heating it up...
Forum: Dual Sport/Enduro 10-27-2024, 07:31 PM
Replies: 50
Views: 2,014
Posted By Thumper
Oh. It certainly looks better. Does the mid...

Oh. It certainly looks better. Does the mid section of the right side panel deform when you cinch down the tank? I was able to force the thing into place but not without severe force and those two...
Forum: Dual Sport/Enduro 10-27-2024, 06:04 PM
Replies: 50
Views: 2,014
Posted By Thumper
minor tail section mount mod

Actually, I think that the fact that these bikes all have the same issues is a good sign of consistency in the manufacturing process. Not perfect, but I didn't pay nearly enough for perfect!

Here...
Forum: Dual Sport/Enduro 10-27-2024, 11:15 AM
Replies: 50
Views: 2,014
Posted By Thumper
My header and tailpipe were misaligned on the...

My header and tailpipe were misaligned on the Templar as well. I was never satisfied with the seal at the header, went through a few crush gaskets fooling with it. It had to be flexed to mount the...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 06:44 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.