Quote:
Originally Posted by JTCAndrew
I had moved the clip closer to the point - I just moved it back to the orig oem position - If this does NOT Work I may have it figured out. The plunger has a plate on the inside there are three holes two are for screws. The other can be covered or uncovered based upon how that plate goes in. I have it uncovered. Which looks to be correct based upon a picture in the portguees manual. Going to put it back togather now and fire it up. We will see! 8O
Andrew
|
Andrew, I would move the clip down yet another notch. If you're already at the bottom notch, I'd buy a bigger main jet. Just because a certain size main jet worked for somebody else doesn't mean it's right for you.
Also, what position is your air / fuel screw in?