ChinaRiders Forums - View Single Post - Zongshen 200GY-A, rehab exhaust question

tankme · 07-17-2014, 04:28 PM

Then I have to be visually missing something. I guess I am not keying in on how the pipe has anything snugging it to the exhaust port.

Thanks for the different diagram, at least it's the same as the older one I have so that's a plus. I'm headed back out there to take another shot at it.

And if I am good to that point am guessing I am now just looking to purchase a replacement gasket, mid-pipe and muffler. Suggestions on what and from where? I was poking around and spotted some full sets so far but I haven't gone farther yet.

I'll be back in a bit either relieved or even more daunted.
Jim

07-17-2014, 04:28 PM	#3
tankme Join Date: Jul 2014 Location: Texas Hill Country Posts: 144	Then I have to be visually missing something. I guess I am not keying in on how the pipe has anything snugging it to the exhaust port. Thanks for the different diagram, at least it's the same as the older one I have so that's a plus. I'm headed back out there to take another shot at it. And if I am good to that point am guessing I am now just looking to purchase a replacement gasket, mid-pipe and muffler. Suggestions on what and from where? I was poking around and spotted some full sets so far but I haven't gone farther yet. I'll be back in a bit either relieved or even more daunted. Jim __________________ 2008 Zongshen 200GY-A, HS163FML : Needs: Battery, Battery Box, Both clutch and brake handles, exhaust system, all plastics, gas cap, starter rewired. Her name will be Phoenix. 2007 Shineray Speedee 150, 1P57QMJ: Needs: starter rewired, exhaust connected, cleaned up, ignition switch simplified, new seat and lights, new front and back racks. There's no such thing as a free puppy or motorcycle. I think I have caught the fever from y'all.
	0