Here is how to modify the turn beeper.
Behind the front headlight fairing there will be a small plastic box. Inside is just a simple RC (resistor/capacitor) circuit to generate the flasher interval. To be able to get in there you have to remove the two 10mm bolts on the sides of the fairing and tilt it back. Some times pictures are worth a thousand words so take a look. Remember I have completely removed my piezo so it is not there. You can do the same or just put some scotch tape over the small hole in it to quiet it down if you choose to leave it. Also you can see how I black taped the hole to protect the circuit from moisture. Again multiple posts to show the pictures.
Matt
Quote:
Originally Posted by mmprestine
The irritating turn signal buzzer lasted about ONE turn. Ha Ha I made a funny! Only picture I have but it was very simple. Take the black box apart and clip the small black piezo speaker wires to remove it. Also taped the hole as water would just fill up the plastic box.
|