[SpudRider]

Originally Posted by rjmorel

Wow you guys spend more money on brush guards then I do on tires :
I'm going to try these ones off fleabay. But then I am thrifty, frugal and cheap. I'm sticking with only Chinese made parts . Don't trust any of them fancy Japenese or Merican made ones. Back at all you nay sayers . rj

http://www.ebay.com/itm/201289587784...84.m1436.l2649

Originally Posted by Huck369

I'm cheap too. I've. Used those on streetbike for wind protection, for which they work fine, but they are just flimsy plastic and offer no fall Protection, so procede with that in mind...

Originally Posted by Weldangrind

I'm also cheap; that's one of the reasons I'm here.

I've used these on a few bikes, and they're terrific. Spoilers are also available for them: http://item.taobao.com/item.htm?spm=...id=17327821918

That works out to $9.66 USD.

All China Riders are frugal; that's why we're here.

I was going to order the Taobao 'Acerbis' hand guards, but I decided to wait until my next order, Weld. Can you provide a link for the spoilers? One would also need to buy fat bar adapters for those 'Acerbis' hand guards.

The Tusk hand guards work very well, and are the least expensive, wrap-around hand guards which are available domestically. I have them mounted on my Zongshen ZS200GY-2, and my two Honda motorcycles. Each of the individual parts for these hand guards is also sold separately, and they come in a nice variety of colors.