[SpudRider]

Yesterday, I was heading out for a ride, and the bike stalled several blocks from my home. I turned the key off/on for three cycles, as described in the link below, to get a diagnostic code from the ECU.

http://www.chinariders.net/showpost....8&postcount=17

I received fault code 0351.

After a minute or so, I got the bike started and rode back home. I looked up the fault code, and discovered I had a problem with the ignition coil. I examined the ignition coil for damage, and tested the connections leading into the ignition coil, and at the spark plug. The spark plug connection was a little loose, so I pushed it down all the way. The bike started, and I went for 120-mile ride without any further problems.

If you haven't already done so, I suggest you check to make sure the spark plug cap is fully seated.