Quote:
Originally Posted by woodlandsprite
...As for the screw - it's the bottom one that holds the split panel that houses the air filter
the one referred to in post #9 in this thread ![Smile](images/smilies/nod2.gif)
|
Quote:
Originally Posted by SpudRider
I'm sure that screw is metric. I will try to remember to measure it for you when I get a chance. ![Wink](images/smilies/windfk.gif) I merely removed that screw, and did not replace it. I think the other screws will hold the panel securely. ![Smile](images/smilies/nod2.gif)
|
I measured the screw. It is designed for a 3 mm hole. However, I don't know the thread pitch.
![Shrug](images/smilies/shrug8.gif)
I assume it is the standard thread pitch for a 3 mm screw/bolt.
__________________
Spud
"Never argue with an idiot. He will drag you down to his level, and beat you with experience."
![Wink](images/smilies/windfk.gif)
Mark Twain
2015 Zongshen ZS250GY-3 (RX3)
2006 Zongshen ZS200GY-2 (Sierra 200)
2005 Honda XR650L
2004 Honda CRF250X
1998 Kawasaki KDX220
Mods made to my Zongshen ZS200GY-2:
http://www.chinariders.net/showthread.php?t=6894