Quote:
Originally Posted by Weldangrind
Could your lights be simply clamped to the outside of the guard, similar to how Huck installed his? May we see a pic of your installation?
|
I suppose, as long as the up/down left/right adjustment is where you want the beam. These are VERY bright very focused spots with quite some throw as they have glass projector lens.
Again, I wanted them protected in a spill.
Here is a bit better pic. You can see that the cage is no longer in line with the clamp.
The clamp has two screws bolting it to the cage. Fixed in position.
All I did was disassemble the light, removed the REAR of the two screws holding the cage on, tightening the remaining one pretty tight.
Then reassemble light in cage, clamp assembly where you want it for up/down, and then turned the entire cage left/right to where you want it. The one screw will hold that position while you take the cage back apart. Then drill the new offset rear bolt hole in the cage. Reassemble and voila
