ChinaRiders Forums - View Single Post

SpudRider · 04-12-2016, 11:07 AM

Post Edited to Correct Errors

Here is a photograph of the SKF 6202 2RS bearing I installed in the sprocket side of the rear hub. Since I have an earlier version of the rear hub, I only installed one of these bearings. The bearings in the brake rotor side of the hub are 6302 2RS bearing.

I used the orange pick to pry open the rubber seals from the inside diameter of the bearing. I packed the bearings with Lucas Red "N" Tacky #2 grease. The photo also shows my 15 mm split collet, and the large driver I used to drive the old bearings from the hub.

04-12-2016, 11:07 AM	#43
SpudRider Join Date: Jul 2008 Location: Idaho Posts: 25,054	Post Edited to Correct Errors Here is a photograph of the SKF 6202 2RS bearing I installed in the sprocket side of the rear hub. Since I have an earlier version of the rear hub, I only installed one of these bearings. The bearings in the brake rotor side of the hub are 6302 2RS bearing. I used the orange pick to pry open the rubber seals from the inside diameter of the bearing. I packed the bearings with Lucas Red "N" Tacky #2 grease. The photo also shows my 15 mm split collet, and the large driver I used to drive the old bearings from the hub. __________________ Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain 2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 Last edited by SpudRider; 05-30-2016 at 02:27 AM.
	0