ChinaRiders Forums - View Single Post

Merlin · 04-09-2017, 06:34 PM

Well I lowered my engine and adjusted my valves to .05mm in and .08mm out. The intake was too tight and the exhaust was too loose. I also installed a oil cooler. Now my bike wont idle. The idle varies 500 or so rpm and is way low and the bike will stall if I don't keep on the throttle. Its always been rock solid before. Would the valves being out of adjustment do this? In the past when I've seen this it was a vacuum leak. I had the T on the flywheel lined up and both rocker arms had play.

04-09-2017, 06:34 PM	#1
Merlin Join Date: Jun 2016 Location: Colorado Posts: 1,107	Valve adj now ruff / low / no idle (problem solved) Well I lowered my engine and adjusted my valves to .05mm in and .08mm out. The intake was too tight and the exhaust was too loose. I also installed a oil cooler. Now my bike wont idle. The idle varies 500 or so rpm and is way low and the bike will stall if I don't keep on the throttle. Its always been rock solid before. Would the valves being out of adjustment do this? In the past when I've seen this it was a vacuum leak. I had the T on the flywheel lined up and both rocker arms had play. __________________ Bashan Blaze Mods: Alloy Rim's, Muffler, Mukuni VM26 Carb, Foam Filter, Tachometer, Volt Meter,LED Headlight, LED Blinkers Last edited by Merlin; 04-10-2017 at 04:54 PM.
	0