So there I was getting the China Bike ready for a weekend ride with Detours... and the Bashan license plate, brake, and turn signal holder finally decided it was time to fall apart into 14 pieces... soo I started looking around pops garage and found a (free) replacement...
If anyone else has the same problem, I found that an old License plate off a car will work as a substitute
only need a hammer, a drill and some bits, a file, and a cutting tool to complete the yob
Took this pic when I was almost done, just had the right side to cut, fold, and reattach the turn signal... I might paint it black and put some kind of rubber around the sharp edges, but other then that I'm a happy recycling camper because the China bike is once again "on the road"
