Quote:
Originally Posted by JerryHawk250
As Megadan stated. Put a thin screwdriver between the 2 halves that the bolt goes through to spread it apart. That lever got bent in pretty far. Bend it out far enough to clear the case and you should be good to go.
|
Yes, the lever is bent in too far. But don't try to rebend it on the bike. Tap that screw driver, or whatever you were using in the video, just enough to get it free enough to get it off. Then bend it back out, or buy a new one. I think CSC has them. There are guys on here that can post a link to CSC, if you decide to go that route. When you bend it out, make sure you bend it out enough to clear the outside of the case by a 1/4 / 3/8ths of an inch. It must not touch the case anywhere in its travel. Let us know if that fixes it. If it does, than we will get to the clutch issues....ARH