|
Morning, tapping you again,,
So I, if you recall, I did the under the seat mod for an air filter as water is an issue where we run.
Once done and tight after starting the unit, it was bogging down as soon as I applied throttle is the issue. It can idle easy enough and running half throttle ok, but when opening it up the unit "bogs down".
On one of them, 150bull, The setup is; the carb, to a rubber 1.25 to 1.5" fitting, to a pvc extension tail piece (11" long), to a pvc 45deg elbow to a cone airfilter under the seat. I needed the 11" piece to get to the seat as the carb sits further away.
It only does this with the pvc extension piece & '45deg elbow & cone filter attached.
It runs fine if I just keep the rubber fitting and the immediate cone filter.
Is there a carb adjustment I missed in the details?
I'm a bit skiddish with carb "tuning" only due to unfamiliarity with playing with these chinease carbs..and them getting easily out of whack excetra..
sorry so long winded..
|