Linseed oil is the best thing to use by far, once it dries it creates a film that not only acts as an oxygen boundry, but also acts almost like a water proof coating.
It's also not the most safe or friendly thing to use thanks to its combustible nature, so care needs to be taken when working with it.
Quote:
Originally Posted by Riggs
Maybe a pic as well that is not zoomed in 4 inches away from location lol
Dan, Could you explain exactly where water intrusion is located & where to access the hole to be plugged & hole to be drilled if so desired. Thank you.
|
The open ends of the tubes are at the very rear of the frame of the bike, right behind the tail light/rear fender area underneath.
The hole he drilled is at the very bottom of that same tubing right where it meets the frame in a Y. On the right side it would be just below the middle exhaust mount location.