I got some more grinding, cutting and welding(chinese style
) done today.
I can now drop the engine in there any where I want it and just have to wait for parts now.
After measuring I think I can use the manifold I found but wont know for sure until it gets here.
So there isnt much room for the carb just yet as you can see in that picture but I hope the intake I have found will drop the carb downand over to the side just enough.
So I need :
a 12t #520 counter sprocket
a blaster chain set
and most likely I'll just buy a blaster swingarm bearing kit.
After I get all those parts I should be able to atleast get the engine mounts done then it all down hill.