|
Update.
Checked for indications of air leaks like broken spacers or manifold, etc. all looked OK.
Filed the manifold to head spacer to ensure it was flat.
Also filed both ends of the manifold.
No O-ring on the manifold to head spacer so I made a gasket for each side of the spacer.
Cleaned the O-rings on both carb to manifold spacers and filed the non O-ring sides.
Still runs the same. Starts great on choke, barely off choke it starts to run on regular idle(very fast if I have it set a little higher) then dies once the choke is open much more than 1/8.
I'm fine with getting a new carb if needed, as long as it's an air leak and not the carb. Any other places to check for air leaks?
What carb would be best to replace this and bolt right in and where to buy?
|