ChinaRiders Forums - View Single Post - Working With Diagnostic Data Cable & Software

Ifstewart · 05-10-2020, 01:41 PM

Thanks for your reply. It is a Delphi MT05 ECU. It is the same engine as is used on the CSC RX3. I'm using version 1.2 of ECU Hacker. When I hit connect, it says select a COM port. I'm assuming the drop down next to the Connect button is for COM port selection, but there is nothing there to select from. I installed the 3.5 version of the driver as well.

05-10-2020, 01:41 PM	#189
Ifstewart Join Date: May 2020 Posts: 3	Thanks for your reply. It is a Delphi MT05 ECU. It is the same engine as is used on the CSC RX3. I'm using version 1.2 of ECU Hacker. When I hit connect, it says select a COM port. I'm assuming the drop down next to the Connect button is for COM port selection, but there is nothing there to select from. I installed the 3.5 version of the driver as well.
	0