Quote:
Originally Posted by China Rider 27
Alright! It is time for the numbers. How to get a CG motor to approach CCW's results is the quest!
|
If that were my goal, then I would start with this cam.
https://wgkindustria.com.br/produtos...-alta-rodovia/
Port the head and use proper multi angle valve seat cuts with back cut stainless valves, The above pushrods, better valve springs because you WILL have valve float issues, mill the block a couple of mm to reduce the quench gap to less than .035" And then have a custom forged piston made because your compression ratio after that jug being milled will be right around 12:1 on a stock one.
Then you just need a 32mm carb.