Quote:
Originally Posted by JFOlivier
GoJimH, I would like to do the same with my Lifan x-pect, where did you get the 17 tooth sprocket and do you have the part number. I have checked out some sites for a JT 1264-17 and the parts they show differ in the inside spline configuration.
|
JFOliver,
I installed the front sprocket today and it fits. A couple of cautions / notes:
1. The back wheel was off the ground during installation. That helped.
2. The bolts that hold the sprocket retainer on are soft and will break easily. (Please don't ask me how I know)....
3. Clearance is tight. When replacing the housing cover on - I had to work with it - and - rotate the back tire a little. Luckily I had read about this somewhere else. At first you think it just wont go - but it did.
In the pics below - I think my angle makes the clearance look worse than it is.
Once again - my thanks to JerryHawk250, Landshark and everyone else who commented here.
STOCK SPROCKET:
NEW SPROCKET
