Quote:
Originally Posted by goat67
Rewire Hazard Switch to Kill Switch
From the post I made on how to wire the switch
I rewired this today. Interesting the blue and orange flasher wires have a diode in line.
The three wires you need to modify are the blue, orange and gray wires.
I took the switch and harness off the bike so I could remove the wires from the molex plug.
To remove the wires from the plug use a small screwdriver or dental pick to push the holder on the pin.
I removed the harness cover at this point you will see where the blue wire is spliced and another wire is added the orange wire and the diodes are placed in line.
I cut the the blue wire before the splice and then I spliced in a wire to match the length of the gray wire.
I cut the gray wire to remove the connector. You now have the two wires you need to splice into the ignition switch harness.
I removed the green and black wire with white stripe from the molex connector.
I then used an exacto knife to remove about 3/8 inch of insulation right before the pin.
I then soldered the blue and gray wires to the green and black/white stripe wires.
I used shrink tubing to finish the wires up and put the wires back into the molex connector.
I now have a kill switch. and no emergency flashers.
|
This seems to be what I am looking for.