Quote:
Originally Posted by Dusman
1. Yes, case is slightly marred from the seal being removed where the screw I used to take the seal out nicked the case. The nick is more toward the outer edge of the case, but it still could create a valley for leakage.
|
So you need to repair the case where the nick is. Perhaps a bit of JB Weld on your finger, to fill in the scratch, then wipe off any that is not in the scratch. Let it set up a day, then install a new seal.
If it is too hard to get your finger in there, you could use a pipe cleaner, Q-tip, etc.