|
Here are a few pictures of the saddle bags i made up for the Kids TT250...
the steel I used is 1 1/4" wide x 3/16" thick ( thinner 1/8" is too weak)
the Harbor freight cases are bolted on in 5 or 6 places with large fender washers on both sides of the plastic in a few places where it's rather thin.
I added a 1/2" round rod across the back for added support. they turned out fairly WIDE
but at least they shouldn't be melted by the exhaust pipe. <GRIN>
here's the pics.
Bob.....
__________________
It's too late when you've gone too far !
|