Nibbi carb is in. I lucked out and it came with a 32 pilot installed. Small victories. Clutch cable and throttle cable have been adjusted with proper slack.
I need to pick up a 55mm hose clamp for the intake (the largest I have is a 52mm). With that everything is locked in place and I can start putting more of the bike back together.
I also managed to find a better spot to mount the coil as well.
Things to complete:
- Fill radiator
- Fill engine with oil
- Put new master link on chain
- Set chain tension
- Grease front axle
- Torque front axle
- Drain and refill gas tank
- Remount front brake
- Refill and bleed front brake
- Exhaust
*NOTE: please don't judge me too harshly for those
terribly cut coolant lines. I didn't swap out razor blades until it was far too late.