View Single Post
Old 11-01-2009, 08:01 PM   #15
waynev   waynev is offline
 
Join Date: Aug 2009
Location: London, Ontario
Posts: 1,097
PCD, if the rubber looked bad to start with then you probably weren't going to get a good seal anyways, but if you re-read my 1st post it says you must be able to put them back in by hand, if you needed a clamp then you added too much tape in the groove.

One thing to remember is the nitrogen is supposed to be sealed in that rubber cap, the seals on the outside of that cap is what keeps the oil from leaking out and the nitrogen from leaking into the oil. IMHO i think those rubber caps are defective.


 
Reply With Quote