|
Hap, Thumper, thank you all so much. I will definitely dig into this carb with my more mechanically-inclined buddy, hopefully this weekend when he's off work, and though he and I neither one are very much experienced on carb work, hopefully we can figure this one out with your knowledge and tutorials.
I was afraid where these are still fairly new to the market that there wouldn't be any help on particular things I run across, but glad to see there is a wealth of info here. Thanks again! I'll message back once I've gotten to try this out and see what my results are.
As for the washer needed to do the job, is that something I should be able to find at my local hardware store? Not sure what diameter/circumference I need to look for but once we tear into it I'd say it will become a bit more apparent.
|