[QUOTE=ChondaChondaChonda;286384]This is a quick picture documentary of the easy way to install the NC300 big bore kit - several members have had trouble getting the rings into the cylinder. Part of this is because the new cylinder doesn't have an angled approach like the stock cylinder does. (Not enough meat left?? ) Not sure why, but it can make assembly difficult, especially if you put the piston on the rod end first and then try to push the cylinder down over the rings. It's very unstable and a tight space to work in.
I actually put the piston in from the top, I found that easy enough.
You could always use the tool to compress the rings etc but there are a few ways that does not make not hard.
I def think piston in jug first then lower the jug on to the engine and then put the wrist pin into the piston etc etc
|