ChinaRiders Forums - View Single Post - Wiring Diagram for my Hensim 150cc GY6 ATV

wvcruffler · 01-02-2009, 02:35 AM

[quote="LynnEdwards"]A while back I had a minor problem with intermittent no spark on my 150cc Hensim GY6 quad. It was caused by a flaky tether kill switch which I have since replaced. But I didn't have a wiring diagram so I got a little obsessed and traced the whole thing out from stem to stern. In case this might be of help to others with wiring issues I'm going to attempt to post it. I've never done this embedded picture thing before, so lets see if it works:

Lynn,
What did you replace the tether killswitch with? Mine is way tight. I think it would remove my hand if I fell off this thing. Other than that I am pretty happy with my Hensim 150.

01-02-2009, 02:35 AM	#3
wvcruffler Join Date: Jul 2008 Location: West Virginia Posts: 19	Re: Wiring Diagram for my Hensim 150cc GY6 ATV [quote="LynnEdwards"]A while back I had a minor problem with intermittent no spark on my 150cc Hensim GY6 quad. It was caused by a flaky tether kill switch which I have since replaced. But I didn't have a wiring diagram so I got a little obsessed and traced the whole thing out from stem to stern. In case this might be of help to others with wiring issues I'm going to attempt to post it. I've never done this embedded picture thing before, so lets see if it works: Lynn, What did you replace the tether killswitch with? Mine is way tight. I think it would remove my hand if I fell off this thing. Other than that I am pretty happy with my Hensim 150.
	0