|
ok, thanks for all your replies, i think i have found the issue, after a good look over the cables and rest of the bike i noticed the chain was a little slack. pulled the front spocket cover and noticed the chain was able to spin with the engine off while in netural and 1st , so pushed it out into the yard and started it up , put it in first and the chain started spinning but not going anywhere. looked at rear sprocket and all the bolts were broke off clean.
So it looks like engine , clutch and all are good, but the bad news is how to get the sprocket bolts out , i also think i saw a post some where about the Bolts being soft and how some people replaced them with honda bolts. any ideas on best way to get them out and other ideas of stuff to check while i am at it?
|