|
Too busy riding the RX4, no time to post about it. Just turned over 500 miles so I did the first oil change. Same process like the RX3. Take out drain plug, take out strainers, take out and replace the filter. I have their after market aluminum skid plate. It has a hole designed in it below the oil drain plug. I did not remove the skid plate to drain the old oil. Yes, some did spill on the inside of the skid plate and even on the exhaust, but most drained out of the hole as designed. I just wiped it off best I could when the job was done. Much easier than removing the skid plate. After 500 miles of daily commuting use, all is good. It is a nice bike.
|