Quote:
Originally Posted by SGCSCRX3
Well at close to 3,500 miles I figured I would give them valves a check. First owner did the first 500 mile check. All seemed good for my first time doing this. Intakes were good ...Exhaust was slightly tighter so I adjusted them slightly. I have them to the .006 -.008 spec. This is my first time doing this so I am putting it back together and test ride time. I didn't pull the gas tank just in bolted and lifted aside. Also I unbolted the abs and pushed it out of the way to gain access to the exhaust valve cover. Otherwise I follwed the instructions per CSC site.
|
That valve spec should be .003" if you used a standard set of feeler gauges, .06-.08 mm is the metric equivalent and you appear to have conflated the two. If you really did adjust them to .006" it won't destroy the engine or anything, but the valves are going to be noisy as hell and you will probably have to do it over.