[Ficnarr]

Thanks for the responses! I appreciate any and all help as I’m a noob when it comes to bikes.

I pulled the sensor out of the tank and checked the ohm readings. It measured between .08(empty) and .95 (full). I was able to trace the wiring up to the display gauge, I did not however undo the entire bundle to check the full run of wire. I didn’t notice and breaks or loose connections. When I put everything back together I noticed the fuel gauge reads correctly but only when I am up around 4500 rpm. It will come on faint but won’t stay. Any ideas?

Thanks again for the welcome and the advice/help