12-05-2015, 07:01 AM | #1 |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
Zongshen RX3: Clutch Assembly
Clutch System Access
To access the clutch you only need to remove the 5 bolts holding the clutch cover. You don't need to remove the entire right crankcase cover to service the clutch. After removing the clutch cover, loosen the six bolts incrementally in a star pattern to remove the clutch pressure plate. After removing the clutch pressure plate, remove the push rod cap, roller bearing, and washer. During clutch reassembly, the cap is placed over the push rod, the needle bearing is placed upon the push rod cap, and the washer is placed last, so it makes contact with the clutch pressure plate. Verify the proper position of the clutch cover gasket by noting the small notch in the gasket located near the top bolt hole.
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain 2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 Last edited by SpudRider; 12-08-2015 at 02:31 PM. |
|
|
|
|
|