new tbr7 carb problems

[Digbyz]

put a new keihin pz30 on it .it only runs with a 45 / 115 jets ,three turns out, and third slot down on the needle. Now Im at 700 ft, any thoughts ??

[Megadan]

Originally Posted by Digbyz

put a new keihin pz30 on it .it only runs with a 45 / 115 jets ,three turns out, and third slot down on the needle. Now Im at 700 ft, any thoughts ??

Need a bit more than that, but I can tell you that 3 turns out on a 45 pilot is definitely not right. Have you checked the float height? Page 3 on this PDF, the PZ26 example of float height also applies to the PZ30's on our bikes. http://www.ccwthariders.com/uploads/...ing_manual.pdf

Assuming float height is set correctly, the next thing I would check for is that you don't have a vacuum leak. That would play hell with all of the mixture settings.

Also, what mods, if any on the bike?

[pistolclass]

Dan correct me if I'm out of touch but my hawk was shipped with tight valves and that needs ro be checked first, right?

[Megadan]

Originally Posted by pistolclass

Dan correct me if I'm out of touch but my hawk was shipped with tight valves and that needs ro be checked first, right?

Also a possibility, yes.

[Digbyz]

I have two hawks both run 40 / 110 , two turns and two washers . maybe a little lean . ive had this tbr7 for a month ,still doesn't run.
it can with a broken primary jet. had to buy a new carb .

[Digbyz]

Ok I checked the float level .good. sprayed it down , no vac leak. The only mod is cat removed. Ok 45 / 110 jets ,third slot on needle . will not run in the middle ..

[Digbyz]

Ok im going with 40 /110 adjust the needle up to the forth slot . Starting there again. I took the carb all apart and cleaned .Hope this works