07-14-2016, 10:45 PM
|
#1 |
Join Date: May 2016
Location: Bismarck, ND
Posts: 868
|
Hawk turn signal alarm
Is there a link on how to disable the alarm? I turned the ignition switch on in my shop and the turn signal was on. My dog and I have trust issues now.
__________________
2015 and 3/4 RPS Hawk 250. Most people would call it a 2016 but the MCO didn't. |
|
|
07-14-2016, 10:48 PM
|
#2 |
|
Join Date: May 2016
Posts: 231
|
If you look at the bottom of the blinker module(under the seat) I believe you should see an opening at the bootm. If you stuff some paper towel in there it will muffle it. If you are ok with making a permanent change you can take it apart and clip the wires for the speaker. I was amazed at how tiny the speaker is yet it makes such a loud noise.
__________________
Hawk 250 with following performance mods: 17t, Mikuni with 110/25, Uni filter, Exhaust. |
|
|
|
07-15-2016, 12:05 AM
|
#3 |
|
Join Date: May 2016
Location: Bismarck, ND
Posts: 868
|
I found the flasher and unplugged it. No turn signals and no alarm now. The flasher box is sealed but does have some movement were the connections go into the box.
__________________
2015 and 3/4 RPS Hawk 250. Most people would call it a 2016 but the MCO didn't. |
|
|
|
07-15-2016, 12:13 AM
|
#4 | |
|
Join Date: May 2007
Location: Lac Du Flambeau, WI
Posts: 804
|
Quote:
The cover will pop right off. Not sealed tight..... |
|
|
|
|
07-15-2016, 12:29 AM
|
#5 |
|
Join Date: May 2016
Posts: 583
|
I taped over the opening to quiet the alarm. It's good to have a reminder the signals are flashing.
|
|
|
|
07-15-2016, 12:37 AM
|
#6 |
|
Join Date: May 2016
Location: Bismarck, ND
Posts: 868
|
I used a couple of small precision screwdrivers to pop the end of the box off. That speaker is tiny but it has a big bark.
__________________
2015 and 3/4 RPS Hawk 250. Most people would call it a 2016 but the MCO didn't. Last edited by hertz9753; 07-15-2016 at 12:39 AM. Reason: adding picture |
|
|
|
07-15-2016, 01:26 AM
|
#7 |
Join Date: Mar 2008
Posts: 2,436
|
SpudRider, pls include this topic in FAQ
Old thread: http://chinariders.net/showthread.php?t=16442
__________________
Last edited by humanbeing; 08-25-2016 at 09:59 AM. |
|
|
|
07-15-2016, 01:29 AM
|
#8 |
|
Join Date: May 2016
Location: Bismarck, ND
Posts: 868
|
I snipped the wires and pushed on the speaker with my finger and it came loose. I don't need an alarm when I have four lights in front of me that I can see on the Hawk.
__________________
2015 and 3/4 RPS Hawk 250. Most people would call it a 2016 but the MCO didn't. |
|
|
|
07-15-2016, 11:51 AM
|
#9 | |
Join Date: Mar 2009
Location: Sardis, BC, Canada
Posts: 25,977
|
Quote:
__________________
Weldangrind "I figure I'm well-prepared for coping with a bike that comes from the factory with unresolved issues and that rewards the self-reliant owner." - Buccaneer |
|
|
|
|
06-13-2018, 07:39 AM
|
#11 |
Join Date: Sep 2017
Location: N Texas
Posts: 706
|
That was the first thing i did to my hawk. snip that wire!!!!!!!!
|
|
|
|
06-13-2018, 11:14 AM
|
#12 | |
|
Join Date: Mar 2009
Location: Sardis, BC, Canada
Posts: 25,977
|
Quote:
__________________
Weldangrind "I figure I'm well-prepared for coping with a bike that comes from the factory with unresolved issues and that rewards the self-reliant owner." - Buccaneer |
|
|
|
|
06-13-2018, 01:09 PM
|
#13 |
Join Date: Oct 2015
Location: connecticut
Posts: 978
|
I kinda like mine. It gets the attention of folks at stop light so I hoping it increases my chances of awareness that I'm there.
|
|
|
|
|
|
 |
|
|
Linear Mode
