Brozz 1000 mile review-Beating on the Brozz

[goat67]

Originally Posted by 1DeltaBlu

I'm curious to know how you did this... Was it hard? Did you watch any sort of video or just knew what you were doing?

Here are the instructions

The three wires you need to modify are the blue, orange and gray wires in the switch harness.

I took the switch that we want to modify and harness off the bike so I could remove the wires from the molex plug.

To remove the wires from the plug use a small screwdriver or dental pick to push the holder on the pin.

I removed the harness cover at this point you will see where the blue wire is spliced and another wire is added the orange wire and the diodes are placed in line.

I cut the the blue wire before the splice and then I spliced in a wire to match the length of the gray wire.

I cut the gray wire to remove the connector.

You now have the two wires you need to splice into the ignition switch harness.

I removed the green and black wire with white strip from the molex connector.

I then used an exacto knife to remove about 3/8 inch of insulation right before the pin.

I then soldered the blue and gray wires to the green and black/white stripe wires.

I used shrink tubing to finish the wires up and put the wires back into the molex connector.

I now have a kill switch. and no emergency flashers.